The Series 130 Charging Tool is the interface adapter for a refrigerant/oil charging system. It is designed with minimum refrigerant loss to atmosphere. The manual clamping mechanism used is the time proven BalLoc method. This tool is designed to operate with the Mass Flowmeter Refrigerant Charging System. The tool contains multiple separate fluid circuits, controlled by air pilot pressure, which may be used for vacuum, refrigerant, salvage, oil, or any other fluid.
Tools with automatic clamping are available.
Features
- Minimum Refrigerant Loss
- Manual disconnect
- High vacuum & refrigerant flow rates
- Lightweight
- Connection to a variety of process fittings
- Relief style refrigerant & oil valve
- Air operated vacuum valve
- Easily adapted to different style process fittings
- Easily modified for multiple refrigerants
- Optional selector switch for multiple charge size
- Independent stem operation
- Scavenge optional
Specifications
- Factory Air Supply: 70 psig (4.9 kg/cm2)
- Vacuum Port Fitting: 1/2″ JIC Flare
- Refrigerant: 3/8″ JIC Flare
- Oil Port Fitting: 3/8″ SAE Flare
- Air Port Fitting: 1/4″ Dia. One Touch Connectors
- Weight: 2.4 to 10 lbs (1.09 to 4.54 kg)
- Vacuum Range: 0-760 TORR (0-760 mmHg)
- Refrigerant Valve: Opens with pressure air @ 70 psig
- Oil Valve: Opens with pressure air @ 70 psig
- Vacuum Valve: Opens with pressure air @ 70 psig
- Standard Charge Rate: 50 to 300 g/s
- Maximum Refrigerant Pressure:
- 200 psig @ 70psi air
- 300 psig @ 80 psi air
- 400 psig @ 90 psi air
- 500 psig @ 100 psi air
- Air Pilots: (Vacuum, Refrigerant, Oil)
- Tool Valve Block Flow Capacity (Refrig., Vacuum, Oil): 0.9 Cv (Typical)
- Process Fitting Compatibility: PCU or Hansen Fittings
- Process Fitting Clamp System: PCU BalLoc
- Electrical Connection: 165-15 Amphenol 9 Pin Receptacle
- Oil & Refrigerant Compatibility: Depends on Combination (Contact PCU Engineering)
